Example Schematics and Firmware
Symbol and Footprint
Please select the correct file for Altium/EasyEDA and download the zip corresponding to that. In each file is a symbol and footprint that should just import and be ready to use.
Example Layout 1 - Breakout
This schematic is designed to be as minimalist as possible but a great place to start.
It includes
x2 Standard JST-GH 4 Pin connectors providing Power and Signal in.
A Solder Pad Jumper to enable the 120 ohm Termination Resistor
Every Edge Pin broken out to 2.54mm headers
20x20mm & 30.5x30.5mm M3 Mounting Holes
Example Layout 2 - ESP Telemetry
This schematic is designed to utilise the Mavlink bridge available to ESP devices and simply connects the UART from the CAN Node to the UART on the ESP Device. Flash the ESP before permanently soldering!
It includes
x2 Standard JST-GH 4 Pin connectors providing Power and Signal in.
A Solder Pad Jumper to enable the 120 ohm Termination Resistor
Headers for the Wemos D1 Mini Pro v4
Last updated
